Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Whoknowsknows

3D printing

Thanks for the replies. What I should have said was that I was looking into 3d printing machines for a possible future purchase. We currently outsource some parts by sending off IGES files of our SW models. I just watched a clip about the Makerbot. Anyone have any views on the cheaper end of...
- Whoknowsknows
- Post #4
- Aug 11, 2011
- Forum: DASSAULT: SOLIDWORKS 3D Design
3D printing

Does anyone have some experience using 3D printing from SolidWorks models? I'm interested in the machines and software.
- Whoknowsknows
- Thread
- Aug 10, 2011
- Replies: 14
- Forum: DASSAULT: SOLIDWORKS 3D Design
SW Toolbox

Thanks. I've created my own. I want to make several different lengths head height configurations. I change the length and the cut thread stays the same so interfering with the head on shorter bolts.. How can I configure the helix height?
- Whoknowsknows
- Post #4
- Mar 23, 2011
- Forum: DASSAULT: SOLIDWORKS 3D Design
SW Toolbox

Hi,Where in the solidworks toolbox will i find the following:'7/16UNF x 11/4 Hex Set Screws SAE Grade 5' ?
- Whoknowsknows
- Thread
- Mar 22, 2011
- Replies: 7
- Forum: DASSAULT: SOLIDWORKS 3D Design

Part and Inventory Search

Top Bottom