Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by whippo

  1. whippo

    rolling an eccentric cone

    Pretty much any (larger) sheet metal shop could knock up an oblique cone in 2 mm st/st. A set of 75mm rolls would be able to roll it, although it would be tiring to make a lot of them.
  2. whippo

    Serial port specs for CNC press punchs

    Hi all, I'm currently writing software to send part programs from a PC to a Strippit CNC press punch (it has the HECC80/1 control) The company I work for won’t buy the software. If I can get enough information/setting about/for other press punchs I'm hoping to inculde them in it. I have sorted...
See more

Part and Inventory Search

Back
Top Bottom