Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by waltryan1
-
co-axial features
Re: Fig. 4-24 in ASME Y14.5-2009, and Fig. 4-19 in ASME Y14.5M-1994. Did they put positional tolerancing without a datum back in the standard when I wasn't looking?- waltryan1
- Thread
- Replies: 5
- Forum: Drafting Standards, GD&T & Tolerance Analysis
