Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Vroaar
-
Rivet Standars
The short answer: the protruding shaft length = 1.5 x the rivet diameter. Before setting the rivet of course. The long answer: check out the AC 43.13-1b at FAA.gov.- Vroaar
- Post #2
- Forum: Aircraft engineering
