Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by VolEngineer
-
Dimensioning/tolerancing question
All of the suggestions make sense in the context of my drawing. Thanks again!- VolEngineer
- Post #8
- Forum: Mechanical engineering general discussion
-
Dimensioning/tolerancing question
Thank you for the help guys!- VolEngineer
- Post #6
- Forum: Mechanical engineering general discussion
-
Dimensioning/tolerancing question
I am trying to interpret a drawing done in French. My question is regarding the following: = 70 = <------------------------------> I've never seen a dimension presented like this and could use some help. What do the equals signs signify? This type of dimension is given...- VolEngineer
- Thread
- Replies: 8
- Forum: Mechanical engineering general discussion
