Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by vkopey

  1. vkopey

    How to build the axisymmetric model in Abaqus CFD ?

    btrueblood, I understand, thank you.
  2. vkopey

    How to build the axisymmetric model in Abaqus CFD ?

    Even this 1/4 model is calculated more than 8 hours. I need to calculate 10 such models. I search the way how to reduce the calculation time.
  3. vkopey

    Abaqus Error: Abaqus/CAE Kernel exited with an error.

    I use Abaqus 6.11-3. Sometimes, after long time calculation and using user python scripts Abaqus exit with error: GUI detected error while waiting for ipc connection to close. Abaqus Error: Abaqus/CAE Kernel exited with an error. I searched about this problem and found this advice: GUI detected...
  4. vkopey

    How to build the axisymmetric model in Abaqus CFD ?

    btrueblood, I try to model the ball check valve. I can not pick the pipe axis as the symmetric axis because Abaqus does not allow it. Abaqus support only 3D and 2D-plane CFD models. The question is how to build the axisymmetric model by setting axisymmetric Boundary Conditions on 3D or 2D-plane...
  5. vkopey

    How to build the axisymmetric model in Abaqus CFD ?

    Need help to build the CFD model of the ball valve in Abaqus 6.11-3 (see picture). The problem is that calculation 3D model takes a long time. I tried to build 2D-planar model (see right picture) where: 1 - wall, 2 - inlet velocity, 3 - outlet pressure, 4 - symmetry BC (normal velocity = 0)...
  6. vkopey

    Please help to improve the CFD model of the ball valve

    Please help to improve the CFD model of the ball valve in Abaqus 6.11-3. I attached the model file. The problem is that calculation takes a long time and sometimes (when mesh is a smaller) ends with the error. Maybe something wrong in the Boundary Conditions or in the Predefined Fields. If not...
See more

Part and Inventory Search

Back
Top