Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by VinceA

  1. VinceA

    Microstation Tutorials

    thanks everyone for your advice!
  2. VinceA

    Microstation Tutorials

    I am a young engineer, and my Project Manager informed me today that we will be using Microstation to prepare as-builts. i have some experience with Autocad, and virtually none with Microstation. Are there any suggestions as to which online tutorials or instructional booklets are beneficial?
  3. VinceA

    RCP Diameters

    Im looking for something that shows the o.d. of rcp at different d-loads, can someone point me in the right direction, thanks!
  4. VinceA

    vacuum lines and egr.

    why would it cause detonation?
  5. VinceA

    Ways to get rid of turbo lag

    yeah, i knew that the detonation/ octane rating on the fuel would be the limiting factor. i just remember that my old roomate had like 11:1 compression and he was boosting slightly uner 10 lbs. on 100+ octane and there negligable lag, but having that said, there are a lot of factors that would...
  6. VinceA

    Ways to get rid of turbo lag

    what if you just increase the compression ratio, wouldnt this decrease lag?
  7. VinceA

    vacuum lines and egr.

    yeah, thi is on an 87 celica, i have a leak from a broken egr controller/switch, which seems to be causing a sporatic idle. i think think that if i plug the line on the manifold, the problem will be fixed, i just wanted to be sure that no damage would occur from me doing this
  8. VinceA

    vacuum lines and egr.

    If i remove the vacuum lines to the egr controller, are there any adverse affects aside from extremely high emmisions release?
  9. VinceA

    Good drafting program for structural engineering firm?

    We have the same problem here, we have 10 draftsmen, all use R14, and haveing to save as, save as and what not. Ideally 2005 would be the best, it is not too much different, but its improvements are helpful
See more

Part and Inventory Search

Back
Top