yeh,I am a designer in morimatsu group(china).
The fact is that our client told us the VAULE, but he was not sure about them. He let us verify the Ss, S1, TL VALUE.I hope someone can help me check them. You know i am a chinese, I am not familiar about the ASCE 7-05 and the project seems very...
Who can help me? I almost lost my way!
Who can help me find out the Ss, S1, TL value in the ASCE 7-05 standard. I try to solve it using the steps in Section 11.4 by myself, but it seems quite difficult for me to finish it, so i need your help! your early reply will be great appreciated! The...
Hi, Ganfoss2
That's a wanderful argument! I am a designer in MORIMATSU GROUP (CHINA). We often do the CASE USING BOTH ASME AND GB150-1998 for the clients all over the world. www.morimatsu.com.cn
I think the main differences between ASME VIII-1 & GB150 are the following:
allowance stress(safy...
dear all
thank you for your reply.
i use COMPRESS for the designing. but COMPRESS does not supply a method for BELLOW.
i also use PVElite to calculate the BELLOWS, but some steps do not meet APPENDIX 26.
i think the 'UG-29' rule maybe 'UG-28' which is mentioned in appendix 26-6.5.2, but...
koplan
thank you for your reply.
there is another item which is more worth expecting. that's calculation about BELLOW according to APPENDIX 26 which is constrained by ASME. now i have to calculate it by hand. it's a very tiring thing. do you have a good way to deal with it?
I have some suggestions about the COMPRESS software, maybe it is not intended as a venue for technical support and should not be used as the primary means of technical support, but it will be more convenient for the USERS.
1. Can COMPRESS report CONTENT with page numbers?More and more customers...
The new defaults file will load the following vessel design information:
Internal design pressure and corresponding temperature
External design pressure and corresponding temperature
MDMT and Test temperature
Vessel diameter
Tangent-to-tangent length
Internal and External corrosion...
