Recent content by victroladoctor

Yes they are solids. I found out about Object Enablers and need to down load the correct ones. I believe the file I received was an ACAD MEP. My ACAD Arch 2010 displayed them correctly although my ACAD 2008 did not. Thanks

When I open and/or merge and/or append some Acad files into Navisworks some of the objects come in as wire frame instead of solids. What can I do to correst this? Thanks

Thank you very much.

I must have switched a toggle in 2008 and can only have one drawing open at a time. In 2002 this was just a check box under options / systems / general options. Where do I find this in 2008? Thanks

Has anyone found anything useful on the actual pour pressures when using super plastisizer.

The whole drawing was converted from a pdf and somehow the scaling was off. I tried to make the whole drawing a block but ACAD was asking for a parameter and it would not accept any answers I gave it. If you could explain how to scale a block in one direction, I would appreciate it. The...

Is it possible to scale one in the x direction and not in the y direction?

TY both I am running reg autocad 2008. I didnt think it was possible now I have confirmation.

I have a drawing with points and I have been asked to creat a tri-mesh for AGTEK to read. Is this possible and if so How?

I am trying to create a topographic map given 4000+ points in a spreadsheet and was wondering if the spreadsheet could be imported into autocad.