Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Vessel-SA's latest activity
-
Vessel-SA replied to the thread nozzle-head PWHT.I sent the model to COMPRESS support and asked the same question. They agree that the weld thickness is greater than 1.5", but they use...
-
Vessel-SA replied to the thread nozzle-head PWHT.Thank you,
-
UW-40 Is telling you that you need to take into account either the thickness of the nozzle (set on), thickness of the shell or head (set...
-
Vessel-SA replied to the thread nozzle-head PWHT.but COMPRESS does not agree with 2.042" as the governing thickness and it uses 1.5" (the nominal head thickness) for PWHT check
-
Vessel-SA said "thickness of the groove weld across the nozzle neck is 2.042" (because it is hillside)" PWHT is required.
-
Vessel-SA replied to the thread nozzle-head PWHT.Yeah, that's what I was referring to in my original post (though there was a typo — I meant UW-40(f)(5)(d)). but the question is whether...
-
Vessel-SA replied to the thread nozzle-head PWHT.A drawing of what? I think I described everything needed. Please let me know if there's anything missing that you need to know to share...
-
Hi everyone, I am designing a pressure vessel per ASME SEC VIII-1, there is a hillside (offset) nozzle on a head with a nominal...
