Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by verknde

  1. verknde

    Single Point Herringbone

    Do you have a 5x simultaneous capable machining Center available? Regarding the Herringbone type: which module? Take a look on www.depo.de. In the English pages you will find a brochure which describes the 5x gear milling with pictures step by step in practice. Additionally there is a brochure...
  2. verknde

    AGMA 9 vs. AGMA 10

    I would like to add the following point under consideration: While the gear quality of cylindrical involute gears are based on the measurement of profile, lead, pitch and run-out, the bevel gear quality is only defined by the measurement of the pitch (single, cumulative and pitch error) and...
  3. verknde

    SAE 16/32 17 teeth splined shaft template anybody??

    You can get support by GWJ Technology Braunschweig Germany. Their Software tools TBK and e-assistant will meet your requirements and I guess it is possible to get a user flatrate for gear calculations - so it is not necessary to buy the Software when you have those cases only from time to time...
  4. verknde

    Gear protection from corrosion without oil & grease

    I fully agree with Terry. Basic questions must be clarified. I would like to add the usage of special coatings. For example I remember the company Balzers Oerlikon, coating type Balinit C(R) "WCC" coating for the assembling of gear units and the dry usage without lubrication. It is a coating...
  5. verknde

    Hobbing VS Profile Milling, Invomilling technology

    Firstly it is important to know that 5-axis milling of gears is an extension for a flexible production of gear geometries with pros and cons. This technology does not replace the traditional methods like hobbing and the use of gear shapers, grinders and gear shavers. This technology is not...
See more

Part and Inventory Search

Back
Top