Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Venom2012
-
Ripples on .25 .38 and .50 hrs steel after a corner
Hello I am running a f1 4020 6000w co2 amada laser I am having issues where after my sharp corners I get ripples on my .25 .38 and .50 hrs steel I have tried the recovery but I am having trouble all my holes are coming out great and after about an inch it smooths back out but it just can't seem...- Venom2012
- Thread
- Replies: 0
- Forum: Laser engineering
