Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by vccn

  1. vccn

    3d

    ok guys help very much appreciated. thanks a lot
  2. vccn

    3d

    ok thanks a lot :) by the way wich command use to turn view from 2d to 3d? thanks again
  3. vccn

    3d

    Hello, i am a begginer and my question is very basic. if i have a 2d drawing is it possible to turn on an isometric view and start working in 3d? thank you very much for any attention anyone can give on this
See more

Part and Inventory Search

Back
Top