Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by vasudevan2k
-
Very large blind flanges
a condenser cooling water system with 5100mm diameter pipe has a 2000mm drain connection which is guided upwards and need to be closed with a blind flange. The Flange thickness for the blind as per UG34, SecVII,Div1, equation 2.5,1 works out to about 114mm. Are there codal provisions whereby I...- vasudevan2k
- Thread
- Replies: 1
- Forum: ANSI (standards) Code Issues
-
Large diameter pipe bends and mitres
Where can one find practices, sample drawings and codes for fabrication of mitres , bends and wye joints for pipeline of large diameter (1200mm to 5000mm dia)like bend radius, minimum / maximum angle of each mitre , joint crotch plates,reinforcement etc?- vasudevan2k
- Thread
- Replies: 4
- Forum: ANSI (standards) Code Issues
