B16.5 gives guidance as to acceptable bolting materials to be used for flange bolting. In Table 1B, different grades of SA-193 are categorized as either high, intermediate or low strength. In addition, the notes to this table include statements such as 'nuts may be machined from the same...
Does anyone know if collar nuts with a swivel washer are acceptable to use for B16.5 flange bolting applications?
I have an application where a blind flange is bolted on and off a mating flange several times per day and the blind flange is starting to wear at the nut bearing surface. I want to...
Thanks for the replies. I am not custom designing the racking, nor is it a new installation, otherwise I would expect load capacities to be provided by the manufacturer. Rather this is 20 year old Redi-Rack pallet racking. 20 years ago, there were few regulations governing the installations...
I am a mechanical engineer (thermo/fluids, process system, component design) that has been assigned some additional duties. I was wondering if any structural or industrial engineers could point me towards some good resources regarding the following topics:
1) Pallet Rack Design: Specifically...
I am a mechanical engineer (thermo/fluids, process system, component design) that has been assigned some additional duties. I was wondering if any structural engineers could point me towards some good resources regarding the following topics:
1) Pallet Rack Design: Specifically interested in...
Thanks RCHandy, I can see that this is the approach that has been typically taken for dealing with taper threads.
What I am wondering is: does the code require one to consider the gradual reduction in wall thickness due to the taper itself? If the mating (female) fitting does not engage the...
The ASME B&PV code gives an eq'n to calculate minimum required pipe wall thickness for given pipe dimensions (OD,ID), design pressure and allowable stress on the pipe material. The eq'n also includes an 'A' factor, which is to account for additional thickness required for, say, material removed...
I have found the yield stress of the studs to be 115ksi, as per sect. II, Pt.D, table 3. 70% of this value gives me a preload stress of 80.5ksi. The studs have UNC threads. The bolt preload requirement was specified by my customer (they have also specified a minimum gasket preload stress of...
SnTMan: Do you mean use the actual gasket width to calculate my actual gasket stress based on the preload? If so, this is what I have done to obtain the 30ksi value. Or are you referring to using the actual gasket width as opposed to 'b' in the bolt load/flange stress calculation?
unclesyd...
I am designing a flanged connection to the rules of Sect. VIII - App. 2 (actually Sect.III, App. XI, but its the same procedure). I am using a corrugated stainless steel gasket at the connection, for which app. 2 gives a minimum seating stress of 7600 psi. Using this gasket stress, I calculate...
flatlander1: Very little difference between throttling and control, I was just using the terms to differentiate between flinana's application where a manual valve is adjusted to provide a set flow rate (or pressure...etc), then locked in that position and left there, and (what I would consider a...
flinana: Since the valve you refer to is manually operated and is used in more of a throttling application than a true control application, it won't make a big difference whether it is installed shaft horizontal or shaft vertical. It is, however, a good idea to check with the manufacturer as...
