Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Uniax

  1. Uniax

    wire beam element deletion

    Hi FEA way! thanks for the answer. But i already tried a lot of things but the problem is that i want the wire to disappear in case of excessive COMPRESSIVE load. The closer i found was *tensilefailure but it only condider positive stress. If i put a negative value then, at the start of the...
  2. Uniax

    wire beam element deletion

    Hi everyone, I have a model made of wire beams. I am running an explicit analysis. I would like to know if there is a way to delete beams during the analysis whose stress exceeds a certain amount. In my case i would like to delete them once they exceed a value of direct compressive stress. Thank...
  3. Uniax

    Residual stress

    Hi ! Thanks for the reply ! Do i have to download a particular module to do this or is this possible with ABAQUS itself ? Thanks
  4. Uniax

    Residual stress

    Hi everyone ! I would like to obtain the residual stress after a simulation of stamping and reintroduce it into a the formed part to make further structural analysis. So i have a few questions. The first one would be, is ABAQUS the adapted software to do that ? i would use plastic and...
See more

Part and Inventory Search

Back
Top Bottom