Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by umbach

  1. umbach

    Mechanical Properties of Aluminium Alloys

    Been out of aerospace for a little while but we used to use the following 3 specifications; QQ-A-200 for bar and rod; QQ-A-225 for extrusions; QQ-A-250 for sheet and plate. These 3 specs will give you required minimum values for Tensile, Yield (0.2% offset), and % elongation
See more

Part and Inventory Search

Back
Top Bottom