Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Uge

  1. Uge

    *HELP. Need Help to Stop Electrofin Coated Coil from Dripping Water*

    Although it could be, we doubt that is the problem. Another approach is to use a Zince based primer (ZCR) for instance. But we do not know how well it will adhere to the electrofin coating...
  2. Uge

    *HELP. Need Help to Stop Electrofin Coated Coil from Dripping Water*

    We have used the electrofin coated evaporator coils w/o any problems to date until now. One of our units is in a high humidity environment and the coil is approx. 15-30deg off vertical. It has an Electrofin (polymer) coating. Water is dripping off the coil and creating puddles. The unit is...
  3. Uge

    State Space representation for Economic Modelling

    Hi I am looking for guidance into designing a state space (phase state) model for economic data with price and time series. Are there Matlab tutorials available specific to state space creation in economic models?
  4. Uge

    Condensation in industrial computer terminals

    I second that, use an absorbent such as silica. A second opinion would be to dehumidify the terminal. Do this by dropping the temperature slowly, then perform your temp shock testt, assuming you can A. seal your unit and create a closed loop dehumidifcation cycle. Eugene evzene@hotmail.com
  5. Uge

    Help on adhesive bonding of electroless nickle plated plastic parts

    Ditto, perhaps you have not yet found the correct adhesive for your materials and possibly you need to prep the surfaces, chemically and mechanically clean them. I would look for thermal cure adhesives if heat is not an issue, you will find best results with those. Gene Packaging/Cooling...
  6. Uge

    Forced Air Cooling

    Also try to break every section of the electronic board into a 2D heat dissipating model and start from there. You will have to make assumptions as you go down the board wrt to air speed and direction but calculating it this way is a good starting point w/o CFD. Funny thing, I did my thesis on...
  7. Uge

    Magic-pak noise level

    Sound data for these types of packaged units is relative to how it was taken, in a closet, in small or big room, indoor/outdoor. I have seen data anywhere from 55-60 dB for SkyMark's SkyPak to 70dB for Lennox's MagicPak. MagicPak, SkyPak and other brand names are usually enclosed in a closet to...
  8. Uge

    High End Packaged Units

    Hmm, try www.skymarkinternational.com
See more

Part and Inventory Search

Back
Top