All parts whether flat, formed or drawn are subject to stress. If not, you don't need that part. Therefore, if the direction of grain is unspecified, then, design or fabricate the part such that the stress is along the direction of grain. And similarly bend or form at 90 degrees to the...
No, concrete dust will not ignite or explode - in fact, might be a good flame retardant. On unknown dust concentrations, I would flame test a small sample in a controlled environment. Check to see whether a chunk of the parent material will burn at different temperatures.
Coins can be produced at slow speeds or at high speeds. In both cases the process is different. At slow speeds, the force is utilized to cause the metal to yeild, work hardening occurs throughout the coining process and therefore higher tonnages is required. At high speeds, the process is an...
Ruediger, one of the finest technical terms dictionary (German/English) that I found was from Siemens AG. Try the Erlangen R&D facility. However, I must admit, even with this dictionary, I ran into some terminology that gave us problems. The German word was "Liboka". This drove us nuts -...
TCWONG, yes there is a relationship between BHN (Brinnell Hardness Number) and UTS (Ultimate Tensile Strength) - generally, the higher the BHN, the higher the UTS. And the BHN is negatively correlated to the toughness. When you go for higher hardness, you are sacrificing toughness and the part...
Chad, I have done Nitriding on Inserts for Die Casting Dies and have some of the answers:
1. Nitriding may be done only after all machining operations such as grinding, lapping, polishing, etc. are completed. The nitrided case becomes glass hard, very brittle and is approx. Rockwell C 70.
2...
Find a machine shop that has a boring mill that can handle the entire machining in one chucking. It is virtually impossible to get a good flat machine base in multiple chuckings - this is beacause the bed and the machining spindle will move ever so slightly during the cut. Also, it is...
Saeed, 76% in Asia is the equivalent of "A" in the U.S. - also, distinction in Asia is "Straight A with Honors" in U.S. terminology.
Please re-write your resume with these important factors. Otherwise, U.S. companies will think that you graduated with a "C".
I...
The upstream O2 sensor is called the "Control Sensor" and the downstream O2 sensor is called the "Monitoring Sensor". Most people refer to these as "Sensors", hence the confusion.
The Control Sensor sets the Air/Fuel mixture and ensures that the mixture is lean...
The original stress was in the direction 90 degrees to the crack - the crack has relieved the stress somewhat and may have changed the direction of the new stress. Fatigue may be a factor. In any case, a detailed analysis needs to be conducted since a crack is the first sign of impending...
Ensure that the final pass has enough material to cut and not scrape - allow about 0.010" for this cut - the feed depends upon the finish desired. A common error is to allow 0.005" or less for the final cut - this is too little material for a cut.
I have a BSME and an MBA from a top US business school, The University of Chicago. My experience with engineering managers is that a good eng. mgr. need not necessarily have an eng. degree.
A degree is the quickest and most disciplined way of attaining knowledge. However, knowledge can be...
All the above ideas are good - I would like to add to the suggestions. Since the final drill will follow the pre-drilled hole, it is a good idea to pre-drill (pilot) using a 2-fluted slot drill (looks like a milling cutter). Slot drills will provide truer hole locations as compared to twist...
