Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by twodoogs
-
Centrifugal Pump By-Pass orifice
Looking for the correct way to size a constant flow by-pass orifice for a centrifugal pump application. Old rule of thumb was 25 gpm per 100 horsepower. Any additional comments??- twodoogs
- Thread
- Replies: 3
- Forum: Pump engineering
