NomLaser,
Had a bad exprience about 12 or so years ago with a cut a shut o-ring. But i take all you points and reearch the data.
I am sure that the tech/tols are better now than they were oh so long ago.
Thanks for all the help
Thanks guys.
I like the idea of soaking up any moisture.
I like the o-ring data, but the shape of the product is not round, and i feel that a o-ring section cut to length and then glued together will not do the job.
But i can take the %ratios etc and make a moulded profile to suit.
Thanks
Hi,
I am looking for some help. I have a consumer product to design. One of the requirements is to have an IP67 rating.
Does anyone have a design of a good seal. The product is 2.5mm injection moulding upper and lower casing.
seal section and compression ratio would really help.
Thanks in...
