Exploded views for presentations. Unexploded assembly drawings broken down into sub-assemblies for machining prints.
I always thought MPIs were for work instructions on assembly lines. The only time I messed with those were in my manufacturing engineering days so I haven't had to make any in...
I don't know of any easy way of doing it...but I do know of a way. You'll probably hate it, haha.(as you should, but I don't know of any other way, so maybe a macro expert can take a stab) :)
1. Create ordinate dimensions as you normally would.
2. Create a note pointing to the feature...
I think what he was trying to say was that adding ballooned BOMS has no relevance to automatically adding X and Y ordinate dimensions to a drawing.
Gwubs- This doesn't answer your question but from my experience with cutting companies, if you give them a couple dimensions on the .dxf and also...
Vincearlia,
I have a very similar setup to what you're talking about. I can run 800+ part assemblies no prob in lightweight mode. The only limitation I've had is when I have those huge assemblies open with multiple (detailed) automotive engines throughout different configurations of the main...
Your picture with all the different sketches is frightening! If I were you, I would try to master setting up different configurations. Based on what I've read in the thread, I'm going to assume this is your first big automotive assembly. I don't claim to know it all, but here are 10 tips I've...
