Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Troach

  1. Troach

    Pro-E Assy to STEP to UG

    Azreal - I orginally used STEP 203. I just tried another translation of the same files and I used STEP 214. I didn't see any reference options in the provided translator menu??? This time I translated all the components first. That was OK. Then I translated the assy file. When I translated...
  2. Troach

    Pro-E Assy to STEP to UG

    The load options are OK. There are components in the Assy Navigator. Like I said, when the part files were translated indivdually, they created two UG files. One which was empty, and one which had the geometry in it. I've just "substituted" the one file referenced in the Assy Navigator to...
  3. Troach

    Pro-E Assy to STEP to UG

    I've translated a STEP into UG and nothing shows up in the UG part file. It is native Pro-E and was an assembly file. It was then translated to STEP and sent to me along with the components. The components, when translated, created two .PRT files, one empty and one with the geometry... I...
  4. Troach

    Insert, IGES... - Dialog Box Missing

    Borgunit... you are "the man"!!! That did it. Thanks for you help!!!
  5. Troach

    Insert, IGES... - Dialog Box Missing

    Basically it gets me to the same place... whether I pick it from the pull down menu, or type the command in, the only prompt I get is at the command line "IGES Filename:" Before I would get a dialog box (where I could browse and pick the file I wanted to import). I can work around it, make...
  6. Troach

    Insert, IGES... - Dialog Box Missing

    I inserted an .iges file and then I did an undo. Afterwards, my dialog boxes disappeared. I changed my "Filedia" setting back to "1" and all my usual dialog boxes reappeared. However, when I go to insert an .iges file into a new drawing, the dialog box does not appear any more. Not sure...
  7. Troach

    How to change units in a prt file

    The converter worked great. Now everything is in the correct units, just 25.4 times bigger than I want it!! :-) Thanks to both and Mr. Morauski!
  8. Troach

    How to change units in a prt file

    I'm new to UG and did a model in inches instead of mm. Is there an easy way to change that?
See more

Part and Inventory Search

Back
Top