Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by TRK110

  1. TRK110

    Multi Link Suspension

    It is called PRO 4. Basically, the only rule is that it has to be a 4 cylinder. Ours has 354hp, and will be in a tube chassis. Suspension is completely open, so that's why were looking for something a little differnent.
  2. TRK110

    Multi Link Suspension

    I am talking about getting power to the ground, getting the tires to "bite" the surface. Since the differential torque reaction is not transmitted through the suspension members directly like with a rear end, I am trying to find a way to get as much power to the ground as possible.
  3. TRK110

    Multi Link Suspension

    I have been researching antisquat geometry today, and I have learned some neat stuff. I found a good program to calculate anitsquat percentage, but so far have only got the demo version which limits you quite a bit. The thing I see though, is that it is designed for a live axle, but I didn't...
  4. TRK110

    Multi Link Suspension

    I appreciate the reply! Is there any way to simplify that down just a little to make it easier to grasp? [tongue]
  5. TRK110

    Multi Link Suspension

    We are designing and fabricating a circle track race car to be run on dirt. It is going to be mid/rear engine and rear wheel drive, therefore requiring independent rear suspension. We've normally dealt with a live axle rear suspension with a 4 link design, so we don't know exactly how an...
See more

Part and Inventory Search

Back
Top