Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Tripton
-
NX5 will not accept less than or greater than expression
Thank you so much John. I don't know how I missed making the arm_length expression constant in CAST. It makes perfect sense now and worked out perfectly. It's little things like this that really make NX overwhelming to some of us new guys. I struggled for hours and even recreated the model...- Tripton
- Post #3
- Forum: Siemens: UG/NX
-
NX5 will not accept less than or greater than expression
I am trying to create a conditional expression and find that using the less than symbol gives the following error: Dimension mismatch (binary operation) Attempt to use the "<" operation on the Length and Angle Expression: arm_angle = if(arm_length<100)(102)else(90) This expression was taken...- Tripton
- Thread
- Replies: 2
- Forum: Siemens: UG/NX
