Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Trashdude
-
Inventor Sheet Metal Cuts
Thanks for getting back to me. I could send you the file but I'm not sure how - on this newsgroup. I have a 10 GA steel plate, 40 inches tall, rolled 180 degrees (15" R)(half of the cyclone barrel. The barrel axis is vertical. I then need to take an 18" diameter tube and insert it...- Trashdude
- Post #3
- Forum: Autodesk: Inventor
-
Inventor Sheet Metal Cuts
I am having difficulty doing cuts in sheetmetal parts that have been rolled I am trying to design a cyclone from 10 GA. I can't figure out how to make a (correct)circular cut tangent to the main body. I can make the cut but the cut edges are not "true" and so the sheet metal will not...- Trashdude
- Thread
- Replies: 3
- Forum: Autodesk: Inventor
-
Internet Explorer Script Error Inventor 5.3
I get script errors when accessing help from Inventor 8 as well. I'm running XP Pro - any suggestions?- Trashdude
- Post #4
- Forum: Autodesk: Inventor
