Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Tort
-
AWS D1.1 Minimum double fillet
where it says maximum plate thickness is for the thicker plate of connection, but where it says minimum plate for fillet on each side, is for the web plate? if this is so ... i cant use web plate thinner than 0.28" in A-50 steel is this right? THX- Tort
- Post #7
- Forum: AWS (welding) Code Issues
-
AWS D1.1 Minimum double fillet
someone send me this table does someone know how to interpret this http://files.engineering.com/getfile.aspx?folder=2e909598-a911-462f-bf6d-b95a5934bc57&file=table5.13.jpg- Tort
- Post #5
- Forum: AWS (welding) Code Issues
-
AWS D1.1 Minimum double fillet
ok as i understand , i can put 1/8" fillet on both sides of the web in 1 single pass; can i use 3/16" welding fillet?- Tort
- Post #3
- Forum: AWS (welding) Code Issues
-
AWS D1.1 Minimum double fillet
Hi and thanks in advance i have a problem with double fillet welding joint for a built up 3 plate beam, theres a concern for the web of the beam , because is a 3/16" plate is it possible to make the double fillet conection for a 3/16" web to 3/8" and 1/2" flange i was reading AWS D1.1 but...- Tort
- Thread
- Replies: 7
- Forum: AWS (welding) Code Issues
