Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Toolinsp

  1. Toolinsp

    Assembly saving problems

    Sorry it took so long for a reply. The file I have has alot of little assembly drawings used within the main file. It seems that they have a library they pick from and then somehow it is referenced within the CAD file. What I would like to do is combine all of those smaller files and save it as...
  2. Toolinsp

    Assembly saving problems

    Good Morning All Does anyone know a way to save a model with drafting sheets that is brought in as an assembly so it is a complete file. Thanks Jim
  3. Toolinsp

    Ortho View Problems

    Thank you Carl. That was the problem. Jim
  4. Toolinsp

    Ortho View Problems

    Hello All I am having a proble with UG 9. I added a new detail and now it is in every ortho view on all sheets in drafting. I have been removing them by changing the boundry, but some of the view just cannot be changed that way. I have moved the detil to a different layer and turned the layer...
  5. Toolinsp

    NX6 drafting a compound angle

    Thank you Dasalo. I read your earlier thread, and I was hoping that you would have responded. I have not had the chance to try what you have described yet, but I will give it a shot. Did you find this easier to do; rather than doing it through modeling? Thanks again. Jim
  6. Toolinsp

    NX6 drafting a compound angle

    Hi all Can anyone tell me how to make a multiply angle setup from a top or front view. I have a setmaster with a compound angle, and I am unsure how to rotate the views from the tooling ball following a specific angle. Thanks Jim
See more

Part and Inventory Search

Back
Top