Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by toolguy2000
-
Type of aluminium to use for good machinability
Hey I'm new to this forum but I've been doing this kind of thing for a while. I would suggest 6061-T6 for your part and follow it up with a hard anodize per MIL-A-8625, type 3, class I. I've used this in Sea water and in direct water contact. It is susepable to crevice corrosion if the anodize...- toolguy2000
- Post #9
- Forum: Material engineering general discussion
