Recent content by toolfnatic

I have searched google and a few other sites?

more mechanical engineering? i just need a few articles

I am looking for some documents on how 3-d software has advanced research? Does anyone know of anything Toolfnatic

I tried something like this. I will try again tommorow.

Can anyone tell me how to use the advance angle mate? There is an: angle value max value min value

Solid works is labeling each dim as it was put on the detailed print ie. the first dim is labeled D1 and so on. Most ISO prints have this designation so that manufacturing can have an inspection sheet for that print. For our application we do not need that level of inspection. Does anyone...

For dimensions on a print does anyone know how to remove the dimesion names or labels? I am assuming this is ISO 9000 thing?

Thanks

How do you go about dimensioning elipses in SW drawing files?

Thanks that was it

When I click on one center mark and then click on another it gives me a dimension like 90 degrees. I am looking for a linear dimension.

I am dimensioning center to center of two holes using the center mark as a refrence

When using smart dimension, vertical and horizontal dimension icon in solidworks 05 for sheet mode. The program autmatically assumes I want an angular dimension there, is there a way to turn this off?