Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by tonyfell
-
Looking for Viscosity vs. Temperature graphs
Check this link out. http://www.xlrotor.com/Lubricant_properties_calculator.XLS- tonyfell
- Post #2
- Forum: Pipelines, Piping and Fluid Mechanics engineering
-
Preventing bearing wear
rnd2 The rotational speed is approx. 4500 rpm. The both bearings are affected, although the bottom is affected to a greater extent than the top.- tonyfell
- Post #7
- Forum: Bearing design, manufacture and maintenance
-
Preventing bearing wear
Hi, I have a drum containing pressurised oil that rotates on a vertical shaft on either bronze or PEEK bushes. The leakage of the oil through the journal / bush clearance lubricates the surfaces and in effect creates a form hydrostatic bearing on either end of the drum. On occasions the oil in...- tonyfell
- Thread
- Replies: 11
- Forum: Bearing design, manufacture and maintenance
