Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Tonglong Song
-
abaqus FE compression simulation
Hi, the FE model is imported mesh and it is curved, is it possible to constrain a tie with the bottom plate? also, for contact pairs there are ~ 20 small meshes inside the big one is it OK to define contact pairs with the small one and the whole big one? I can't seem to select hole surface...- Tonglong Song
- Post #3
- Forum: DASSAULT: ABAQUS FEA Solver
-
abaqus FE compression simulation
Hello, I am new to abaqus and trying to simulate a compression deformation of an import FE model. I defined material properties as a hyperelastic rubber like material, set contact to general contact, modeled two compression plates as analytical rigid bodies, define boundary conditions as top...- Tonglong Song
- Thread
- Replies: 4
- Forum: DASSAULT: ABAQUS FEA Solver
