Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by TomConnell
-
Zero Bend Radius
No is the short answer. However, you can do a bend rad of 0.0001mm- TomConnell
- Post #2
- Forum: Autodesk: Inventor
-
Large Assemblies
So far the largest assembly I've built is a multiple sub assemblies comprising just over 2400 parts. Approx 30% of parts are screws, washers etc. Model rebuilds/updates and editing of parts are instant. Saves can take a couple of minutes (may be the server). I believe that the hierarchy of...- TomConnell
- Post #3
- Forum: Autodesk: Inventor
-
RSe segment streamer
Can anyone help me. I have a full project that has been Pack N Go onto CD rom. However, when I try to open a file I get an error message - Error in reading RSe segment streamer-- TomConnell
- Thread
- Replies: 0
- Forum: Autodesk: Inventor
