Recent content by tombak71

thank you

I am in the process of designing a lifting tong for the rrmoval of cone crusher head distributor plate. Can anyone recommend the web or book resource for design calculations for lifting devices. thank you

thank you guys for your help tombak71

thanx quark

Hi all. I was wandering if anyone can explain or recommend a useful url regarding my question. I am trying to find info on how jammed (seized) trough or return idlers affect the performance of the belt conveyor. Thank you tombak71

Hi all. I was wandering if anyone can explain or recommend a useful url regarding my question. I am tryingto find info on how jammed (seized) trough or return idlers affect the performance of the belt conveyor. Thank you tombak71

thanx brgguy22

yes taper sleeves are used and I have found more info about it from SKF website. Thanks Peter

thanks unclesyd, much appreciated tombak71

Thanks a lot mbensema for very clear information. tombak71

Hello all Question 1 I am currently doing my apprenitceship as Fitter Machinist and recently one of the tasks where I work, was to fit the bearings on the new tail pulley shaft. Shaft size is 50 mm and the bearings that I've used is 22211(SKF). I've mounted the new bearings under supervision of...

Hello all Question 1 I am currently doing my apprenitceship as Fitter Machinist and recently one of the tasks where I work, was to fit the bearings on the new tail pulley shaft. Shaft size is 50 mm and the bearings that I've used is 22211(SKF). I've mounted the new bearings under supervision of...

Hi everyone, this is probably an easy question: How can I hide the formulas so that it's not visible for other users? Thanx Jimmy

Thank you very much guys for your time, I've done it and it makes life much easier. Thanks again Jimmy

Thanx briand2 for the tip, I'll try that