Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by TMP_2024
-
Reinforcement for Rectangular Hole in Flat Tube Sheet
ASME Section IV (Heating Boiler) HG-325 references the reinforcement requirements for circular hole openings in flat heads as A = .5dt with the "d" referring to the diameter of the opening. What would be the proper reinforcement for a rectangular opening (assuming the opening does not exceed...- TMP_2024
- Thread
- Replies: 0
- Forum: Boiler and Pressure Vessel engineering
