I need a recommendation for a specialist in solenoid development to maximize the potential of a solenoid we wish to manufacture.
I would prefer a company in Brisbane Australia but its not necessary.
Hi, I moved this post as I had parked it in the wrong place.... Sorry :sick:
Could people smarter than me fact check or advise where I'm right and where I'm wrong. TIA
I have a need to produce a small run of permanent magnet, Latching solenoid that have =/>15N @12mm - More is better....
I...
It is a straight linear armature pull type with magnetically latching.
It pulls a mechanism that when latched back it reverses the spring action from push, to pull, when the solenoid is released and extended the action reverts back to push type again, beyond this mechanism is a 90° crank to...
Thank you very much for your answer, it's much appreciated.
I will struggle with the packaging of a capacitor, I'd like to explore the single coil, pull type with non-energized magnetically latching if that's possible.
From your answer, my new understanding is...
If I am limited to 24Vdc @...
I'm well out of my comfort zone sorry 😐. I would like to develop our own design and understanding. I have had quite a good look and only seem to find very basic or very advanced topics, I was hoping for some middle ground for dummies
Requirement...
latching solenoids
I hope to get the maximum...
I think Fusion is very good for creating tool paths and strategies for CNC machining (probably the best bang for buck for small volume) and I think Inventor is very good at 3d design.
I haven't used Fusion for design because I have inventor but it does strike me as strange that the 3d modelling...
I watched a video of Alan Jones driving a Williams with no suspension. He wasn't too happy with the ride 🙂.
But it was quicker, I'm assuming it was too hard on the car to continue with and with little controls for individual track/driver setup. He said it might be ok with suspension under the...
Thanks for this Brian.
My mind is all over the place on this, I started out thinking hydraulics then, jumped to electric, then back to hydraulics because I thought, maybe I could add some active component with a pump. Then I wondered how fast the hydraulics could act....maybe with a pump and...
Thanks Greg.
This is a learning curve for me. I enjoy the R&D learning and inventing the most so I'll follow up your leads and see where it goes.
That must have been a great project, it must have been really frustrating when they hit the pause button.
Regards
Dave
I'm headed into retirement and want to plan a toy to build for fun, for me. It won't necessarily make sense to others but it will to me.
I have been around Subaru Impreza Tarmac Rally cars a lot and have a shed full of parts so I'll make use of those.
I'd like to design a space frame for the...
I started design on computers before 3D CAD with Turbo CAD 2D on a 286 computer. It came on 3 floppy discs. I would save up any deleted components for lunch time, select them then go for lunch, it was still working on the edits until well after lunch. Big excitement when the 386 came out with a...
I started design on computers before 3D CAD with Turbo CAD 2D on a 286 computer. It came on 3 floppy discs. I would save up any deleted components for lunch time, select them then go for lunch, it was still working on the edits until well after lunch. Big excitement when the 386 came out with a...
I would think they are both very good, its pretty much at the core of the software. The more complex assemblies test out your computer particularly the video card but there are strategies to minimise this.
I haven't used Solidworks but the people who do seem happy with it. I can vouch for...
