Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by TMARSHALL
-
NX8.5 / NX7.5 drawing
Thank you for trying to help, but that does not work. I found the solution. In drafting, View>Display sheet which turns off display sheet and then Edit>View>Hide Components in a View took care of the parts and sub assemblies float in space, which turned them off in modeling.- TMARSHALL
- Post #6
- Forum: Siemens: UG/NX
-
NX8.5 / NX7.5 drawing
I made views with just the sub assemblies in them on the drafting side of the assembly and another copy of the sub assembly and/or parts shows up in the BOM. The sub assembly and/or parts show up in modeling floating in space and also in drafting too.- TMARSHALL
- Post #3
- Forum: Siemens: UG/NX
-
NX8.5 / NX7.5 drawing
Hi Just opened a drawing that was created in NX7.5 in NX8.5. The sub assemblies used for the views are turned on in modeling and the main assembly views. Is there any customer defaults that need to be turned on to fix this or anything else?- TMARSHALL
- Thread
- Replies: 5
- Forum: Siemens: UG/NX
