Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by TJJohnson
-
Importing Points?
COOL! Ok, I searched all over the place for "importing" points, but now I found that UG calls it "inputting" points. Very cool. This is exactly what I needed. I made the apline, then I just plotted a point set on the spline's knot-points to show the points like I needed. Thanks a million, Tim- TJJohnson
- Post #5
- Forum: Siemens: UG/NX
-
Importing Points?
Well, either one. If I can just get a set of points to plot in space, I can easily grab them all and run a spline through them. In the end though, what I need is a set of points with a spline running thru them. Thanks alot for any help. I just found these forums and am liking what I see when...- TJJohnson
- Post #3
- Forum: Siemens: UG/NX
-
Importing Points?
There has to be a quick way of importing an ascii or a text file of x,y,z coordinates into UG and plotting them as points in space, right? Does anyone have any leads before I start plotting points one by one? Thanks, Tim- TJJohnson
- Thread
- Replies: 6
- Forum: Siemens: UG/NX
