Recent content by timey

I did not know that. Thanks again.

Okay here is an update on what's actually happening. I have modified the explosion by using Hide components in view and turned off items I did not want to see. When I go back to the drawing and update view these items are still there after the update view. Is this something within the view...

Thanks cowski, I have been doing the same as you explained. I have been saving the view after any modifications to the explosion, but not as a new view. I actually had the views update okay since I posted. I normally switch views using the Part navigator under model views and not replace...

Hi everyone, I'm using NX10 and have set up some exploded views within my drawing file. I have created my exploded views and placed them onto the drawing. When I make a change to the explosion and saved the view. I then go into the drawing mode and use update view, but it does not update to...

I'm using NX9 and in some cases when I am constraing a Sketch it will tell me that the Sketch needs 0 contraints, but in the Part Navigator it still tells me that the Sketch in undercontrained. Why, and does this mean that my Sketch is actually Fully constrained. What am I missing. Thanks, Timey

Nevermind about this I found out how to do it. Thanks, anyway.

Hi Everyone, I have just upgraded to NX9 from NX7.5 and can someone please tell me how to edit a component pattern. The pattern I have is a simple circular bolt pattern. I could delete it and re-do it but I know there should be a way to do this. Please help. Thanks, Timey

synchronous commands? can you explain a little more in detail for me?

I am using NX7.53 and have a part that was modeled to show a weld prep (chamfer). For whatever reason my company refers not to show weld preps in an assembly being used to create a drawing and just show the weld symbol at drawing level. Now after promoting the body of the part at assembly...

I'm on NX7.5 and I put a threaded hole in and did a circular array and the counter sink dia changed in the model even though the attribute stayed. Any one know why?

I use these quite often to obtain such things as dia. and deg. and such, but does anyone have a list of all symbols or special features that can be utilized using these? If so please share. Thanks, timey

I could also make this useful, but I don't understand when you say "While in Drafting, but without the Drawing being shown". How do you do that?

Thank You... Timey

7.5

What I have done is simply use the text edit command, copy the text of the note, go to your other sheet, then use the the note command and paste.