Recent content by timagatep

Chicopee, Thanks for the input, I will look into those alternative stiffeners as well.

Hello Mike, Thank you very much for the help! I figured there was some standard table for angles but could never get my hands on it. This will greatly help the project I am currently undergoing. For the skid design, I am looking a steel pallet design. Thanks again!

Hello, I know there is a method for designing rectangular tanks under hydrostatic pressure. I have used the pressure vessel handbook, among other documents for reference. However, I am stuck on how to compute the correct angle sizing for the tanks. On the examples, the process shows how to...