Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by tiktak292
-
Unilateral VS Bilateral Tolerancing
I am wondering if there is any type of drawing that would require the designer to use both Unilateral and Bilateral tolerances in the same drawing? If so what would be an example of one?- tiktak292
- Thread
- Replies: 13
- Forum: Mechanical engineering general discussion
