Recent content by tighthead

No thats not it, thread559-155291 Thats basically the standard SW help. When you have a standard view (not detail etc). We put multiple parts on one sheet & sometimes scale them differently, how can we show the scale for each part on the drawing in a note: We have good reasons to do this.

Tried both ways when it does not work? Can't work out why some will work on drawing then it won't?

How do we include the scale of a view in a note on a draaawing (linked)? SW2005 sp0.

2005 sp0. When dimensioning points on an arc (rolled UB with holes in flange & cleats around arc, point on arc & hole centre line), most of the time I get the arc length dimension I want. Done by, Click on end point, click on 2nd point then click on arc. Sometimes I get the arc length around the...

Sorry about email :( I have put the Spaceball 3003/2003 driver & SW driver on www.driverguide.com enjoy :)

The driver I believe you need is called "3DxWare_v3-6-4_win32_reg.exe" (12468kb un zipped) & for Solidworks (do you still need this? I used it) also "3DxSolidWorks_v2-4-2_win32.exe" (2149kb un zipped). The first is I think the last spacball driver to support 2003? 3003. If anyone has a later...

How can we get SW2005 to round drawing dimensions to the nearest 0.5mm? This is for structural steel and workshop does not work to better than 0.5mm. Reason (this is only 1 example) we don't model to exact is say we want to dimension to the middle of SHS89 (Square Hollow Section) it would be...

Yes the 6800 was NV40 did not see PCI-E & although it registered as FX4000 don't think it was so good as Quadro, best to do the full thing as below, The 4200x8 worked very well softmodded as Quadro. But watch www.newbietech.net Just upgraded at work from GeForce to FX1300, it rocks in...

Hi, i think I had some success with 6800NU. I start with the complete instructions from www.nvworld.ru Rivatuner & softquadro4. Had a 4200x8 to start that worked as Quadro. Then got a partially faulty 6800NU put that in without uninstalling driver & it detected it as FX4000 ! Also there is a...

We are currently on Pro/E 2001 and will be going to Wildfire 2 sometime soon. We have Dell Presision 530 Workstations P4 1.7G Xeon 1 Gig RDRam, FireGL2 64Meg Graphics cards. The graphics are slow slow slow. If we went for Graphics only upgrade what would be recomended? What would be recomended...

Just in case you haven't done so. You create the skeleton from within the assembly. Will have look at how at work to remind my self. Also use surfaces not siolids in skeleton.