Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Thompson Kakain
-
Wireline tool not passing through a particular feet in a tubing
Apparently, Slickline had ran in hole with a guage cutter of 1.86inches OD on their tool string and they passed through the 3rd SSD of this well at a depth of 7457 ft…then they ran a b shifting tool with an OD of 2.0inches and they passed through the HUD at 7457ft after having a little drop in...- Thompson Kakain
- Post #4
- Forum: Petroleum engineering general discussion
-
Wireline tool not passing through a particular feet in a tubing
How is it possible for a wireline tool not to pass through a particular depth but a Slickline tool with a higher OD is going through that depth- Thompson Kakain
- Thread
- Replies: 6
- Forum: Petroleum engineering general discussion
