Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by thirdjean
-
Positional tolerance requirements to attain certain fittings?
Hello, I'm new to designing mechanical components from scratch and therefore I'd like to ask you on how I can improve my knowledge for this. This is the design that I'd like to figure out for: I have a shaft fitting into two holes on the frame (a two-piece assembly) which are about 40mm apart...- thirdjean
- Thread
- Replies: 0
- Forum: Bearing design, manufacture and maintenance
