Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by thelastengineer

  1. thelastengineer

    Machinist sayings or "quotes"

    this is the quote that my old skilled mentor ronnie barron told me "NIL ILIGITIMO DESPERANDO CARBURUNDUM" DONT LET THE BASTARDS GRIND YOU DOWN may the laws of physics be with you regards
  2. thelastengineer

    fanuc control

    Message: any of you guys know how to get a fanuc 15m control to read and execute a one line full circle cut eg on the tosnuc (toshiba )i run a g12/13 g23/22 this runs from the center 45 degree vector in full circle cut and vector off to the center,im not to sure if its a parrameter setting on...
  3. thelastengineer

    Using a Miller to Polish / Linish

    try looking at "3M" products they do a variety of diameter scotch wheels in differing grades , i have a number of jobs i do finishing bores to miro finishes after final boring,also a variety of surfaces polished up the same way. good luck
See more

Part and Inventory Search

Back
Top Bottom