Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by thebiglad

  1. thebiglad

    Run out help

    Its in proprt GDT symbols powerhound a arrow drawn from bottom left of box to top right specifing .0004" in the next box
  2. thebiglad

    Multiple Chamfers

    If the chamfer or rad is the same size i always preffered 1x45 typ or 1x45 3 places with leaders denoting where
  3. thebiglad

    Run out help

    Guys, Can you help i have a shaft with a dia in the middle greater than the shaft. the drawing states one end of the shaft as datum A the other end as datum B. the run out between datum A and B must be no more than 0.0005" the shaft is .3" in dia and 1.5" long. one end and dia of the shaft are...
See more

Part and Inventory Search

Back
Top Bottom