Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Thebeam
-
Problem cutting 8mm stainless
Gas quality or the optics. 8mm are on the limit with that power. The beam- Thebeam
- Post #3
- Forum: Laser engineering
-
Pulse pierce mild steel spraying up!!
There may be many reasons for this phenomenon most common error is the wrong focus point. To large beam diameter that strikes the sheet. The Beam- Thebeam
- Post #2
- Forum: Laser engineering
