Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by TFig
-
Verification of “R” type radii callouts
To clarify, the R callout is typically deployed by our engineers at the end of what might be a milled slot. Say a .500+/-.005 slot with R at the end. Before I retired we required our suppliers to use the slot width to determine the appropriate radius (.250 in this example) and report actual. The...- TFig
- Post #5
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Verification of “R” type radii callouts
Our engineers often use the R symbol to designate a continuous smooth radius on a part. My problem comes from how this is to be interpreted during the First Article inspection? Do you just visually verify that there is a smooth continuous radius or do you actually measure and report an actual...- TFig
- Thread
- Replies: 8
- Forum: Drafting Standards, GD&T & Tolerance Analysis
