Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by TetT

  1. TetT

    Periodic boundaries conditions

    Hello I use Abaqus CAE and I want to applied periodic boundaries conditions at one square RVE. I want that tow parallel face have the same deform. I use Constrains -> Equation but when I choose set ( geometry ) I have the message : " All terms except the first one must use set consisting of a...
  2. TetT

    Job run, but no create output file ( .odb )

    Hello, My job run with successfully, but I do not find output file ( .odb ) in my current directory. Where I can find output file, or how create it ? Regards,
  3. TetT

    Partition cell on a cylinder

    Hello, Thank you very much for your answers. T&T
  4. TetT

    Partition cell on a cylinder

    Hello, I try to mesh a cylinder with spherical end ( picture on attached file ). On the beginning cylinder was orange and I create partitions to change color (yellow/green I can mesh, orenge I can't ). So I have a problem, I do not manage to find goods partitions, I have a difficulty with a...
  5. TetT

    How to do boolean operation ?

    Hello, I have a square ( part 1) and a cylinder ( part 2 ). I want to do boolean operation between part 1 and part 2. I did not found how to do in on-line help. Thank you for your answer. Regards,
See more

Part and Inventory Search

Back
Top Bottom