Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by testarossapete

  1. testarossapete

    dual dimensioning values are the same

    Thanks for your reply, it is set to inches on both because that it the way they set their tolerance here. For instance: 12.260 over 12.240 or 3.1355 over 3.1366. I drew the part at the mean which is what comes up when I dimension a feature but I need the numbers done like above both in inches. I...
  2. testarossapete

    dual dimensioning values are the same

    I just started a new job using Wildfire 2.0 and this company uses inches with dual dimensions in a high low number which is on the top or bottom acording to dimension. Of course the tolerance's are all diffrent too. I am re-drawing hand drawn parts to Pro and I would like to do it right if...
See more

Part and Inventory Search

Back
Top